Article may be outdated

This article is 15 days old. Some details may have changed since publication.

Hacker News·5 min read·hard

Can't fish Ethernet? Use "invisible" fiber instead

_
_mpn_
Can't fish Ethernet? Use "invisible" fiber instead
✦AI Summary

A homeowner describes using 'invisible' fiber optic cables to bypass faulty Cat6 wiring in a townhouse. The solution allows for high-speed networking without the need for invasive construction or landlord interference.

Why it matters

This provides a practical, DIY solution for home networking challenges in rental or historic properties where traditional cabling is difficult.

✦Dive DeeperCreate a free account to unlock

My family owns a NYC townhouse, and with that I had Cat6 cables put in on each floor.

However, more recently, one of the Cat6 cables has gone “bad,” meaning it only does 100 Mbps. While we are nowhere close to Gigabit speeds, very less multi-Gig (despite me having had symmetric Gigabit in the past), it’s still not something I’m happy about.

What do you mean only 100 Mbps? My switch and AP support 2.5 Gbps.

The most common approaches in my scenario are:

When I did use mesh on HPE AP25s (the APs I use), the performance was 120 Mbps at two prior homes, that with thin walls and fiber. I also want VLAN segmentation so a typical consumer Eero or Orbi won’t work.

So what did I do? “Invisible” fiber between two floors.

Continue reading on Headlinne

Create a free account to read the full article.

Read full article →
technologydesign
✦

Get smarter about the news

Sign up free for a feed built around what you actually care about, Dive Deeper research on any story, and the full text of every article.

Create free account

Already have an account? Sign in